Foto nostre o del produttore, verificate sul prodotto reale. L'aspetto può variare, funzioni e caratteristiche tecniche no.
JTAG-SMT2-NC surface-mount programming module for AMD FPGAs, without USB connector – Digilent 410-308-B
SMD JTAG programming and debugging module for AMD FPGAs. It has the same features as the JTAG-SMT2 but no USB connector is mounted: the USB2 signals are routed to pads, so the module can be placed anywhere in the design.
Key features
- Complete JTAG programming and debugging solution for AMD FPGAs in a small surface-mount module, soldered directly onto the target board
- Same features as the JTAG-SMT2, but without a mounted USB connector: the module can be placed anywhere in the design, not only at the board edge
- Compatible with all AMD software tools
- Compatible with IEEE 1149.7-2009 Class T0 to Class T4, including 2-wire JTAG
- GPIO pin allows debugging software to reset the processor core of AMD Zynq platforms
- SPI programming: modes 0 and 2 up to 30 Mbit/s, modes 1 and 3 up to 2 Mbit/s
- JTAG bus can be shared with other devices: signals are held at high impedance except during programming
- Not required with Digilent FPGA boards, which already integrate the programming circuitry
Technical specifications
- Function: JTAG programming and debugging, SPI programming
- Host interface: High-Speed USB 2.0 (signals routed to pads, no connector mounted)
- JTAG/SPI bus speed: up to 30 Mbit/s, user-settable frequency
- Main power supply: 3.3 V
- JTAG signal voltage (Vref): 1.8 to 5 V, via separate Vref supply
- JTAG buffers: high-speed 24 mA three-state
- Mounting: surface mount (SMD)
- Compliance: CE, EU RoHS, REACH
Typical uses
Integration of JTAG programming and debugging on custom boards with AMD FPGAs and Zynq SoCs, in OEM products and embedded systems.
Package contents
- 1 JTAG-SMT2-NC programming module
Warnings. This item is an electronic component (part, board, module or accessory) intended for people with technical skills in electronics, for development, prototyping, education, repair and integration into other equipment. It is not a ready-to-use finished product or a toy and is not suitable for children under 14. Wiring, power supply, installation and use are the buyer's responsibility, following the manufacturer's documentation and the applicable safety rules. Anyone who integrates it into equipment placed on the market becomes its manufacturer and must ensure its conformity (CE marking under directives 2014/30/EU on electromagnetic compatibility, 2014/35/EU on low voltage and, for radio functions, 2014/53/EU). Consumer rights under Italian Legislative Decree 206/2005, including the legal guarantee of conformity, are not affected.
Secure payments: cards, Apple Pay, Google Pay, Satispay, Klarna, PayPal and bank transfer
Express courier shipping throughout Europe
Returns accepted within 14 days