Foto nostre o del produttore, verificate sul prodotto reale. L'aspetto può variare, funzioni e caratteristiche tecniche no.
JTAG-SMT3-NC surface-mount programming module for AMD FPGAs with UART channel – Digilent 410-357
SMD JTAG programming and debugging module for AMD FPGAs with an additional UART channel. The USB D+ and D- signals are routed to pads, so the USB connector type and position can be chosen freely on the board.
Key features
- Complete, self-contained JTAG programming and debugging solution for AMD FPGAs with UART side channel, in a small SMD module reflow-soldered like any other component
- Accessible directly from all AMD tools, including iMPACT, ChipScope, Vivado and EDK
- Dual-channel USB controller for simultaneous access to the JTAG and UART interfaces
- Separate Vref for JTAG and UART: the two interfaces can operate at different voltages
- Open-drain buffer on the PS_SRST_B pin allows debugging software to reset the processor core of AMD Zynq platforms
- USB D+ and D- signals routed to pads: USB connector type and location chosen by the designer
- VBUS_DETECT pin for reduced current consumption when the module is not connected to a PC
- JTAG bus can be shared with other devices: signals are held at high impedance except during programming
Technical specifications
- Function: JTAG programming and debugging, UART bridge
- Host interface: High-Speed USB 2.0 (D+/D- signals on pads, no connector mounted)
- JTAG bus speed: up to 30 Mbit/s, user-settable frequency
- UART speed: up to 12 Mbaud
- Main power supply: 3.3 V
- JTAG and UART signal voltage (Vref): 1.8 to 5.5 V, independent for each interface
- Buffers: high-speed 24 mA (three-state for JTAG)
- Mounting: surface mount (SMD)
- Compliance: CE, EU RoHS, REACH
Typical uses
Integration of JTAG programming and a UART serial console over a single USB port on custom boards with AMD FPGAs and Zynq SoCs, OEM products and embedded systems.
Package contents
- 1 JTAG-SMT3-NC programming module
Warnings. This item is an electronic component (part, board, module or accessory) intended for people with technical skills in electronics, for development, prototyping, education, repair and integration into other equipment. It is not a ready-to-use finished product or a toy and is not suitable for children under 14. Wiring, power supply, installation and use are the buyer's responsibility, following the manufacturer's documentation and the applicable safety rules. Anyone who integrates it into equipment placed on the market becomes its manufacturer and must ensure its conformity (CE marking under directives 2014/30/EU on electromagnetic compatibility, 2014/35/EU on low voltage and, for radio functions, 2014/53/EU). Consumer rights under Italian Legislative Decree 206/2005, including the legal guarantee of conformity, are not affected.
Secure payments: cards, Apple Pay, Google Pay, Satispay, Klarna, PayPal and bank transfer
Express courier shipping throughout Europe
Returns accepted within 14 days