Foto nostre o del produttore, verificate sul prodotto reale. L'aspetto può variare, funzioni e caratteristiche tecniche no.
MAX98306 stereo class D audio amplifier 2 × 3.7 W, 2.7–5.5 V, terminal blocks and selectable gain – Adafruit 987
Small class D stereo amplifier based on the MAX98306: two 3.7 W channels into 3 Ω speakers, over 90 % efficiency and a 2.7 to 5.5 V supply, ideal for portable battery-powered projects.
Key features
- Two 3.7 W channels into 3 Ω speakers (1.7 W into 8 Ω) with a 5 V supply
- High-efficiency class D: over 90 % when driving an 8 Ω speaker at over 1 W, barely gets warm; ideal for portable battery-powered projects
- Fully differential inputs with 1.0 µF capacitors: with non-differential sources simply tie R− and L− to ground
- Bridge-tied (BTL) outputs with 360 kHz PWM averaged out by the speaker coil: the outputs must drive the speakers directly, not another amplifier
- Five selectable gains (6, 9, 12, 15 and 18 dB) with the jumper on the 2 × 4 header or via the G and G' pins
- Passes EMI limits unfiltered with up to 30 cm of speaker cable; spread-spectrum modulation and active emissions limiting
- Excellent click-and-pop suppression, thermal and short-circuit/over-current protection
- Pre-soldered 3.5 mm screw terminal blocks to easily attach and detach the speakers
- A more powerful upgrade to basic LM386 amplifiers
Technical specifications
- Chip: MAX98306
- Output power: 2 × 3.7 W into 3 Ω, 2 × 1.7 W into 8 Ω (10 % THD, 5 V supply)
- Power supply: 2.7–5.5 V DC
- Speakers: 3 Ω impedance or higher
- Gain: 6, 9, 12, 15 or 18 dB
- PSRR: 83 dB at 217 Hz
- Current draw: 2 mA quiescent, 10 µA in shutdown
- Dimensions: 28.1 × 24.0 × 10.4 mm
- Weight: 4.6 g
Typical uses
Stereo audio for portable and battery-powered projects, speakers for Arduino and Raspberry Pi, talking toys and devices, small DIY audio systems.
Package contents
- 1 × MAX98306 amplifier board, assembled and tested, with 1.0 µF input capacitors, 3.5 mm terminal blocks and 2 × 4 header pre-soldered
- 1 × gain selection jumper
- Header pins for breadboard use (to be soldered)
- Speakers not included
Warnings. This item is an electronic component (part, board, module or accessory) intended for people with technical skills in electronics, for development, prototyping, education, repair and integration into other equipment. It is not a ready-to-use finished product or a toy and is not suitable for children under 14. Wiring, power supply, installation and use are the buyer's responsibility, following the manufacturer's documentation and the applicable safety rules. Anyone who integrates it into equipment placed on the market becomes its manufacturer and must ensure its conformity (CE marking under directives 2014/30/EU on electromagnetic compatibility, 2014/35/EU on low voltage and, for radio functions, 2014/53/EU). Consumer rights under Italian Legislative Decree 206/2005, including the legal guarantee of conformity, are not affected.
Secure payments: cards, Apple Pay, Google Pay, Satispay, Klarna, PayPal and bank transfer
Express courier shipping throughout Europe
Returns accepted within 14 days